article number
727218

Brodit fixed installation holder Samsung Note 20 Ult (skins)

€129.95
Out of stock
-
+
  • Fast Shipping
  • High Quality Products
  • Secure Payments
Details
With tilt swivel. Fits for devices with skin; adjustable top.
More Information
More Information
Accessory brand Brodit
Barcode 7320287272185
Recommended retail price incl. VAT €129.95
Holder feature Toestelspecifiek
Toestel connector usbC
Device with or without case without skin
Cable / Qi / charger type / connnector Molex, fixed install
Input Voltage 12/24V geschikt
Voltage (output) QC - QuickCharge
Max Amperage 3,0 Amp
Montage standaard AMPS
Device holder lockable? no
Color black
Productinfo Professional holder with swivel mechanism for your smartdevice. Adjusting holder angle deminishes annoying screen reflection
Product installation Mount the holder on a ProClip in your vehicle. A detailed installation manual is included in the product packaging
Product suitable for In the Compatibility tab, check whether your smartdevice is suitable or listed for this holder
Item Returns This item can be returned
Show more + Show less -
Compatibility
Show more + Show less -
Instruction
Note: The charger unit is fused internally with 2 A automotive re-settable thermal fuse, but if an external fuse is to be installed then connect a 2 A fuse holder and fuse inline with the Red wire close to the power source. Route the cable from the holder into the vehicle dashboard and secure the charger unit in place with the adhesive tape provided. Ensure the charger unit is securely mounted behind the dashboard in a well ventilated area that does not get hot! Note: If you are connecting a GPS/Data device to the holder please ensure the charger unit is located in a position within easy reach of any GPS or charging adapters. Route the power cable from the charger unit to the power supply source in the vehicle and connect as follows: 1. Connect the White wire to a Negative Ground connection of the vehicle or the vehicle chassis.
2. Connect the Red wire to a 12/24 Volt power supply in the vehicle that is controlled by the ignition switch of the vehicle. Attaching the holder: 1. Loosen the screw in the center of the holder so you can remove the tilt swivel attaching plate on the back. 2. Place the attaching plate onto the desired position. Screw the attaching plate into place with the enclosed screws. Place the holder over the attaching plate so the screw fits in the hole in the tilt swivel. Tighten the screw until the holder is firmly in place, but still can be adjusted.
3. To place the device in the holder: Place the upper part of the device in the holder, then press the device forwards and upwards so it snaps into place in the holder. To remove the device from the holder: Press upwards on the lower part of the device, in the same time pull the the device out and down from the holder.
4. The holder is in place.

Scroll to top